請把下列的程式複製到 ./config/config.properties.php 後，再行安裝：
<?php
#
# database settings
#
# Installation instructions:
# NEW INSTALL
# Leave these values blank,
# and go to the URL where you installed pLog
# and look at /wizard.php and type the appropriate
# values in there.
#
# This file needs to be writable
# by whatever user your php scripts run as.
# The easiest thing to do is to make this file
# writable by everyone, and then after the wizard
# completes, remove write privileges from everyone
# except yourself.
#
# UPGRADE
# remove all files from your old plog directory
# (back them up somewhere, also backup your current
# database)
# Upload new pLog files into the same directory,
# and then copy your old config.properties.php
# over this file, and then run the wizard.
# (note, if upgrading between minor releases:
# 1.0 to 1.0.1, etc. you shouldn't run the wizard)
$config["db_host"] = "";
$config["db_username"] = "";
$config["db_password"] = "";
$config["db_database"] = "";
$config["db_prefix"] = "";
$config["db_character_set"] = "default";
$config["db_persistent"] = true;
?>
釋出時沒注意到，忘了 update config file。
Mark
